Learning how to wax jeans yourself is one of the best things you can do if you want to extend the life of your denim garments. By doing it yourself it also saves you money, allowing you to spend a little bit more on your favorite premium denim brands. Waxing is probably the best way to slow down or even prevent fading and whiskering caused by everyday wear and tear.
If you are looking for accurate and correct information about waxing jeans at home then your search is over. Here are five simple steps that will reveal secrets to waxing your own jeans in the privacy of your own home. Follow these easy instructions and you will have a pair of jeans that look brand new, save yourself time and money.
Table of Contents
How To Wax Jeans At Home
If you’re looking for a way to give your jeans an extra rugged look, or if you want to repair the damage caused by wear and tear over time, consider waxing them! This can be done on any type of denim, though it’s most popular on raw denim. Finding a method that suits you best may take some trial and error.
If your jeans have been well-worn before, we recommend washing them first. This removes dirt, grime, and detergent residue that will inhibit the wax from sticking to the fabric.
After washing, dry your jeans thoroughly. Because you’ll be using heat to melt the wax into the fabric, they can’t have any water in them or they’ll shrink!
Once they’re dry, you can use a hair drier to preheat the fabric so that it absorbs the wax better. Be careful not to get too close; it’s easy for your fingers to slip and touch hot metal!
You can either use melted wax, or beeswax pellets.
The first step to waxing jeans is removing the excess dirt. Immerse your jeans in water for about 30 minutes, then rinse out all the dirt and dust in a washing machine. You can also use a scrub brush to rub the jeans if you want, but it’s not necessary. After that, remove your jeans from the washing machine and let them dry overnight.
Once your jeans are dry, start preparing the wax. You can either use melted wax, or beeswax pellets. If you’re using pellets, place them in a double boiler on low heat, and wait until they melt. Once you’ve melted them into a thick liquid, add some oil (olive oil works best). There should be twice as much oil as wax in the mixture.
Once your wax is ready, apply it over the areas you want to distress using a brush. The best way to get a natural look is by applying small amounts of wax at a time because it’s easier to match the color of your jeans this way than with one big splash of wax. When applying the wax, don’t be afraid to use more than one coat if you need to. Make sure there are no air bubbles left after applying each coat
You can use a pinch of fabric dye for colored wax.
You can wax your jeans at home.
Waxing your jeans gives them a distressed look. You can buy pre-waxed jeans, but it’s also fun to do it yourself. The process is actually very simple and only requires a few steps:
Get the right type of wax. You’ll need fabric wax or paraffin wax. These are different from the candle wax you buy for decorative purposes — they are designed specifically for fabrics, so they won’t damage your jeans.
Apply the wax to a corner of the jeans, then rub it in with your fingers or a brush until it’s absorbed into the denim.
You can use a pinch of fabric dye mixed with water for colored wax.
Once the jeans are dry, you can use an old toothbrush to brush off the excess wax.
To wax your jeans, begin by ironing a clean pair of jeans to remove any wrinkles and make them easier to work with. Then, place the jeans on a flat, protected surface and apply the wax along the seams or in any areas you’d like to distress. Once you’ve applied the wax, use a blow dryer to heat the fabric and set the wax in place. Finally, once the jeans are dry, use an old toothbrush to brush off the excess wax.
PREPARE YOUR JEANS
The first step is to iron your jeans so they’re free of wrinkles. This makes it easier for you to apply and smooth out your wax.
Examine your jeans for any stains or areas that need extra attention before you start applying wax. Clean these areas with a stain remover and dry them off before proceeding.
APPLY THE WAX
Spread an old towel on a table or other flat surface where you can work with your jeans. Place your jeans on top of this towel and begin applying the wax to areas where you’d like your jeans to be distressed.
You can use your fingertips or an old toothbrush to apply the wax; both will work just fine. You can also place paper towels inside of the pockets if
If you aren’t sure how much wax to apply, start with less than you think you’ll need.
Waxed jeans are a good option if you’re looking for a more weather-resistant denim. They’re also great if you want to change the texture of your jeans, or give them a distressed look without having to do it yourself.
Here’s how to apply wax to your jeans at home.
Choose the right type of wax. The most traditional waxes used on denim are those made with paraffin and beeswax. These can be found online and in some fabric stores. You can also use candle wax — just make sure it’s unscented and not colored, as these additives could stain your jeans.
Lay down some newspaper or an old tablecloth. Waxing jeans is a messy process, so place something on the floor or table to prevent anything from getting stained.
Fold each leg of the jeans up separately. Fold one pant leg up to the knee and then fold it again so that the opening is facing outwards (as if you were putting them on). Repeat this process with the other pant leg so that only one leg is opened up at a time, preventing any wax from getting onto areas that don’t need it.
Using plain tweezers can help you remove any bits of wax that have fallen off your jeans.
You can buy ready made wax from stores, or make your own at home. To do this, add two tablespoons of beeswax and a tablespoon of coconut oil to a glass bowl. Melt the ingredients in the microwave for about 30 seconds, or until melted.
Once your wax is ready, massage it into the jeans with a ball of cotton. Take care to avoid getting any on the seams.
Once you’re done applying wax, let it sit for about 15 minutes, then use an iron on low heat to finish the process. This will ensure that there are no bubbles or cracks in the wax and will help it set more evenly.
Finally, put on your jeans and walk around in them for at least ten minutes to give the wax time to settle properly.
You can repeat this process as often as needed to achieve the results you want.